|1) Up to ASTM / BS EN / DIN / JIS H standards and so on.
2)Material designation: T2 / C11000 / C102 and TP2 / C12200 / C106 etc.
||C101 / C102
3)Tubes temper: All tempers are available
4) Dimensions: OD: 5-350mm, WT: 0.5-50mm, or according to the buyers requirements, and also length and tolerance
subject to the buyer’s decisions
5) Tubes in good straightness, with clean surface of both inside and outside
6) With pre-shipment inspection if needed, chemical report, mill test if asked, marked tensile strength, yield strength,
elongation rate etc.
7) Typical use of copper pipe and tube: Copper pipe and tube is widely used in Water tubes, condenser, evaporator, and heat
exchanger tubes; air conditioning and refrigeration, gas, heater, and oil burner lines; plumbing pipe and steam tubes; brewery
and distillery tubes; gasoline,hydraulic, and oil lines; rotating bands etc.